MacroSystem Digital Video HDV-Recorder Uživatelský manuál Strana 111

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 112
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 110
111
Bogart SE 5 User manual
8.3.1 Creating DVDs (SD)
When you render a DVD and the RenderBooster is available
and activated, Arabesk will use the RenderBooster instead of
the software encoder.
When the RenderBooster is calculating, both little lamps at the
back of the RenderBooster will alternately light at a fast pace.
The calculation is both faster and more efficient. This means
that, as a rule, you should be able to select a lower image
quality than when you do not use the RenderBooster.
The RenderBooster always uses compressed audio. It is there-
fore not possible to select uncompressed audio when using
the RenderBooster.
The ‘Calculation’ setting has no effect when using the Render-
Booster. The resulting image quality will always be better than
the intensive mode when using the software encoder.
The clearest improvement regarding image quality and calcu-
lating speed is achieved when creating a video DVD from high
resolution source footage (1920x1080, 1440x1080).
8.3.2 Creating AVCHDs (HD)
The RenderBooster can also be used when creating AVCHDs.
When doing so, the RenderBooster is so efficient that even
lower quality levels result in a very good image quality.
The RenderBooster cannot be used for footage in 1280x720
mode.
8.4 Exporting storyboards
The function ‘Exporting storyboard’ will automatically display
new export formats when the RenderBooster is discovered.
Depending on the current project resolution, these are MPEG
2, H.264 or MP4 file formats. The data rate can be set.
These modes are easily recognized because of the addition
‘RenderBooster’. Other modes (MPG, MTS) are not acceler-
ated, but use the software encoder as before.
The acceleration is often considerable.
8.5 Troubleshooting
In case of difficulties with the RenderBooster, you should first
completely switch off the Casablanca and then restart it. Sim-
ply restarting without a complete shutdown is not enough. The
RenderBooster is its own computer and remains unaffected
by a restart of the Casablanca. When the RenderBooster has
become ‘out of step’, its power must be cut by a complete
shutdown. Only then will it restart.
Please note: the RenderBooster should not be connected or
disconnected while the system is in use.
If you have trouble using the RenderBooster for the first time,
it is possible that the firmware update did not succeed. Repeat
the procedure for its initial use.
Please consider: the firmware update can take several minutes
and starts only a short time after the start of Arabesk.
Zobrazit stránku 110
1 2 ... 106 107 108 109 110 111 112

Komentáře k této Příručce

Žádné komentáře